DNF Controls 2034CL-N-PBIO - Manual (Page 6)

6 2034CL-N, 300 Clip Instant Access System, NATIVE Protocol with PBIO Option
DEFINITIONS
Throughout this document, the Grass Valley Group Profile will be referred to as the “Video
Server.”
The ST300-S/SM as the ST300.
The ST420 as the SHOTBOX.
Words surrounded by brackets, for example, [ENTER], are keys on the ST300 or the SHOTBOX.
[XXX] + [XXX] means hold the two keys down simultaneously.
Softkey refers to the multiple functions keys located directly below the display window.
3. SYSTEM INSTALLATION
a. ST300-S/SM, VTR/DDR CONTROLLER
1)
Plug one end of a 9-conductor, RS422 serial cable into the VTR 1 (2 or 3)
connector on the rear of the ST300. Plug the other end of the cable into the
REMOTE connector on the Video Server.
2)
Connect the +5, +12, -12 VDC POWER SUPPLY into the POWER connector
on the rear of the ST300. Plug the Power Supply into an outlet, 90 VAC - 240
VAC.
Do NOT Hotplug!!!
3)
Check SETUP MENU prior to using the ST300 to confirm proper Record mode
and other User settable modes. See CONFIGURING THE PROFILE FOR
NATIVE MODE, Section 22.a.
b. ST420 SHOTBOX
1)
Plug one end of a 9-conductor, RS422 serial cable into the OUTPUT connector
on the rear of the SHOTBOX. Plug the other end of the cable into the “AUX”
connector on the ST300.
2)
Connect the +5,VDC POWER SUPPLY into the POWER connector on the rear
of the SHOTBOX. Plug the Power Supply into a wall outlet, 90 VAC - 240
VAC.