DNF Controls 2034CL-N-PBIO - Manual (Page 23)

23 2034CL-N, 300 Clip Instant Access System, NATIVE Protocol with PBIO Option
21. FUNCTION TABLE
Function Key Press Description
GOTO ENTERED TIME [SHIFT] + [RECUE] Search the VTR to the manually entered time.
Use the ST300 numeric keypad. Press [ENTER] OR
[RECUE].
GANG [SHIFT] + [VTR #1]
OR
[SHIFT] + [VTR #2]
OR
[SHIFT] + [VTR #3]
[SHIFT] + [ANY VTR KEY] gang enable mode.
Then, one at a time, press the VTR keys to be included in the
gang. The LED above the key will turn on.
Press the VTR key again to remove from gang, the LED
above the key will turn off.
Press [ESC] to exit and save the gang.
The VTR LEDs that are on show the gang.
The flashing LED shows which VTR is currently selected
(and is monitoring Time Code on the display).
FFWD
[FFWD] Press and HOLD to shuttle. Release key to stop. Set WIND
Speed in MENU.
JOG
[JOG] Select JOG mode and enable Wheel.
LAST CUE
[LAST CUE] Step to the previous Cue Point Location.
NEXT CUE [NEXT CUE] Step to the next Cue Point Location.
RECORD [REC] Places VTR into the Record mode selected by RECORD
MODE in the SETUP MENU. Press [RECORD] OR
[RECORD] + [PLAY].
REWIND
[RWD] Press and HOLD to shuttle. Release key to stop. Set WIND
Speed in MENU.
SHUTTLE
[SHUTTLE] Select SHUTTLE mode and enable Wheel.
SAVE TRIMMED
CLIP
[SHIFT] +[CLIP LIST]
Save Clip from the IN to the OUT point.
DISPLAY CURRENT
DIRECTORY
[SHIFT] +
[NEXT CUE] Displays the Current Directory.
DISPLAY
DIRECTORY
CURRENT CUE
POINT IS SAVED IN
[SHIFT] + [NEXT CUE]
OR
[SHIFT] + [LAST CUE]
Displays the directory in which the clips in the CURRENT
Cue Point are saved.