DNF Controls 2034CL-N-PBIO - Manual (Page 17)

17 2034CL-N, 300 Clip Instant Access System, NATIVE Protocol with PBIO Option
b. RECEIVE CUELIST FUNCTION
The RECEIVE CUE LIST function allows you to receive your list of Cue Points from a
PC or from another ST300. Transfer to a PC requires OpSuite 3.0 software, which runs
on a Windows-based computer. Contact DNF Controls for more information.
1) TO RECEIVE CUE POINTS FROM THE ST300
a)
Connect the VTR4 connector on the back of the ST300 from the VTR4
connector of the transmitting ST300 using RS422 9-pin cable with TX
and RX lines crossed.
(A “Turnaround” Cable)
b)
Press [MENU] and scroll the Wheel to “Receive CUE List?
YES=Enter, Exit=ESC”
c) Press
[ENTER] to start receiving.
The Display shows “Waiting to receive” on the first line.
d)
When the Transmitter is ready, transfer starts automatically.
The Display now shows “Receiving cuelist.”
e)
After the transfer is over the display shows “Done-Success! Press any
key…”
f)
Press any key. The display shows “Receive cuelist?” message.
g) Press
[ESC] to exit the MENU mode.
2) TO RECEIVE CUE POINTS FROM THE PC
a)
Connect the VTR4 connector on the back of the ST300 to one of the
COM ports on the PC using RS422 to RS232 adapter.
b)
Repeat steps b-g of the RECEIVE CUE POINTS from the ST300
section.
16. SHOTBOX DISPLAY
a. Press
[VIEW]. The VIEW indicator comes on.
b.
Press the desired switch to see the content.
c.
The switch turns RED and the content (CLIP ID) of the corresponding Cue Point is
displayed on a virtual display.
For
Example:
NOTE: All the remaining switches are not illuminated.
d.
Release the keys to return to normal operation.
VTR 1
Clip 23 VTR 2
Clip 13 VTR 3
Clip 77 VTR 4
No Assignment