DNF Controls 2034CL-N-PBIO - Manual (Page 12)

12 2034CL-N, 300 Clip Instant Access System, NATIVE Protocol with PBIO Option
9. TRIGGER
The operator fires a trigger using either the Timeline or Run function on the production switcher.
The ST300 puts the Video Server into the following modes based upon the trigger value:
GRASS VALLEY GROUP
Trigger Value Mode
0 Play
1
Recue to beginning of clip
2 Slo-mo using ST300 Preset Speed
3 Reverse Play
4 Still Frame
5 LoopPlay
6 or greater
Play
SONY
Trigger Value Mode
0 Recue to beginning of clipPlay
1 Play
2
Slo-mo using ST300 Preset Speed
3 Reverse Play
4 Still Frame
5 LoopPlay
6 or greater
Play
To control more than one VTR, enable the Peripheral Device Address for the required VTRs.
The Trigger will be sent to the enabled devices.
OR
GANG the required VTRs on the ST300. See FUNCTION TABLE, Section 21, for GANG
instructions. Enable the Peripheral Device Address for one of the GANGed VTRs. The Trigger
will be sent to the enabled VTR. The other VTRs in the GANG will perform the same action.