DNF Controls 2034CL-N-PBIO - Manual (Page 21)

21 2034CL-N, 300 Clip Instant Access System, NATIVE Protocol with PBIO Option
SWITCHER TYPE Select switcher type. GVG = Grass Valley Group (default) or Sony.
For Phillips DD35 with PBus, use GVG.
PARITY Select ODD, EVEN or NONE. This is the parity sent via the Peripheral Bus to
the ST300.
DATA PORT Select the VTR Connector (1-4) through which the Cuelist may be transmitted
or received.
TRANSMIT
CUELIST
Transmits Cuelist to another ST300 or to a PC.
RECEIVE CUELIST Receives Cuelist from another ST300 or a PC.
SET TO PROFILE
MODE
Press Softkey [YES] to set ST300 to parameters currently stored in the Profile.
UNASSIGNED PORT
OPTION
Recovers Profile resources which have been opened by another device.
Press any key to allow the ST300 to report any unassigned resources.
When prompted, “Press any key for unassigned resources.”
AUTO ALIGNMENT Option will automatically realign slaves which are not on the same connector as
the master. This automatic realignment will occur upon pressing stop or after
one second has elapsed while still.
The second, delayed realignment will occur only in Shuttle, Slomo and Jog.
(Supported ONLY in units with –a option)
ST300 SETUP Press Softkey beneath ClearMem to clear all Cue Points to 00:00:00:00.
Press Softkey [YES] when asked “Are You Sure?”
Press Softkey beneath SetDefault to set ST300 to default settings.
Press Softkey [YES] to save.
ST300 CONFIG Press Softkey [DRIVE], then press Softkeys to save the default drive or turn the
Wheel to change the drive.
Press Softkey [ENTER] to return to the ST300 CONFIG screen.
Press Softkey [DIRECTORY] to save the default directory or turn the Wheel to
change the directory.
Press Softkey [ENTER] to save the selected directory and return to the ST300
CONFIG screen
NOTE: Select default when first setting up the system or when eproms are
upgraded.