DNF Controls 2034CL-N-PBIO - Manual (Page 20)

20 2034CL-N, 300 Clip Instant Access System, NATIVE Protocol with PBIO Option
MARK-Q Press Softkey to:
Enable ADVANCE to next Cue Point, when [MARK] is pressed.
OR
Maintain CURRENT Cue Point when [MARK] is pressed.
TAPE TIME NDF = non-drop frame. DF = drop frame.
STOP MODE PB = while playing a clip, when [STOP] is pressed, the Profile freezes on last
good video.
PB/EE = When [STOP] is pressed the first time, the Profile freezes on last good
video. When [STOP] is pressed a second time, video out is switched to video
in.
WIND MODE Press Softkey to select:
HOLD (fast wind is maintained only while key is depressed).
OR
LATCH (fast wind is initiated and maintained with momentary key press).
Select fast wind speed (04X, etc.) by pressing Softkey.
SLOMO ST300 display shows:
(Non T-Bar Version)
ST300 display shows:
(T-Bar Version)
NOTE - The T-BAR has a fixed speed range of 0 Æ +300 with a detent at
+100% play speed.
For Wheel only:
Press Softkey [SPDRANGE] to select SLOMO speed ranges:
Press Softkey to select: 0 Æ +300 OR -100 Æ +300.
Press Softkey [BACK] to return to SLOMO MENU.
Press [ESC] to exit OR turn the Wheel to select another item.
For Wheel only:
Press Softkey [PRESET] to select the SLOMO Preset Speed Mode.
Press Softkey [UPDATE]. When exiting SLOMO mode, the last used speed is
saved in the Preset Speed register.
Press Softkey [STATIC]. The Preset Speed register is NOT updated when
exiting SLOMO mode.
It is only changed by [SHIFT] + [SLOMO] (PRESET SLOMO).
MAX SHUTTLE
SPEED
Press Softkey to select maximum shuttle speed of the Profile.
PBIO ADDRESS Press VTR key to assign PBIO address.
SLOMO with: WHEEL
SpdRange Preset
Prset
SLOMO with: TBAR
Wheel