DNF Controls 2034CL-N-PBIO - Manual (Page 13)

13 2034CL-N, 300 Clip Instant Access System, NATIVE Protocol with PBIO Option
Advanced Features . . .
10. LOOPING FUNCTIONS
Loop:
Play from the IN point to the OUT point continuously.
Play to Loop: Played from the beginning of clip to the OUT point of the clip, then, playback
continues at the IN point of the clip, then, the clip plays in a continuous loop
from the IN point to the OUT point.
a. LOOP CLIP
1) Press
[LOOP ENABLE] after a clip is loaded to place any clip in loop mode.
To loop clips in GANG mode, the Master Clip should be loaded in loop mode.
All the clips in the Gang will loop when [PLAY] is pressed.
NOTE: Clips will now loop from the IN point to the END of the clip or the
OUT point (if set).
2) Press
[LOOP ENABLE] + [SHIFT] to Play To Loop.
b. SAVING CLIPS THAT AUTOMATICALLY LOOP
To automatically Loop a clip each time it is loaded, DUPLICATE the clip and assign the
suffix “*” to the CLIP ID.
On the ST300: Press [ENTER] + [0] to add a “*” at the end of the clip name.
For example, a clip named TEASER would be named TEASER* to loop each time it is
loaded.