DNF Controls 2034CL-N-PBIO - Manual (Page 15)

15 2034CL-N, 300 Clip Instant Access System, NATIVE Protocol with PBIO Option
12. TRIMMING A CLIP
a.
To make a sub-clip, first LOAD the clip.
b.
Locate the desired IN, then OUT point.
Press [IN]([OUT]) to set the IN(OUT) point. The IN(OUT) indicator will turn on.
c. Press
[SHIFT] + [CLIP LIST]. The display will show:
d. Press
[LOAD].
e. After
pressing [LOAD], the display shows: “Manually enter ID”
Enter a numeric CLIP ID using the numeric keypad on the ST300.
OR
An alphanumeric CLIP ID using the SHOTBOX “qwerty” keyboard, using NAMING
CONVENTIONS, Section 23.c.
f.
Press [LOAD] to save the trimmed clip.
OR
Press [ESC] to abort without saving.
13. RECORDING A NEW CLIP
a.
To make a new clip and insert video from either another Profile channel or an external
source, first press [CLIP LIST]. The Clip List indicator comes on.
b. Since there is no clip loaded, the display now shows:
c.
Press [LOAD].
d. After
pressing [LOAD], the display shows: “Manually enter ID”
Enter a numeric CLIP ID using the numeric keypad on the ST300.
OR
An alphanumeric CLIP ID using the SHOTBOX “qwerty” keyboard, using NAMING
CONVENTIONS, Section 23.c.
e.
Press [LOAD] to save the new CLIP ID.
OR
Press [ESC] to abort without saving.
f.
Recall the Clip and then start the video that will be inserted.
g. Press
[RECORD].
h. Press
[STOP] when finished.
Create New Clip?
LOAD= OK WHEEL= Next
“Save Trimmed Clip?”
LOAD = Yes Wheel = Next