DNF Controls 2034CL-N-PBIO - Manual (Page 10)

10 2034CL-N, 300 Clip Instant Access System, NATIVE Protocol with PBIO Option
d. GOTO TIME
1) Press
[SHIFT] + [RECUE] to enter a search time.
2)
Enter the desired time using the numeric keypad.
3)
Press [RECUE].
OR
Press [ENTER] to GOTO the selected time.
6. LEARN
NOTE: The ST300 and SHOTBOX share common memory in the ST300.
If a LEARN is done on the SHOTBOX, it doesn’t need to be LEARNed on the ST300.
a. LEARN ON THE ST300
1)
Select a VTR by pressing VTR [1], VTR [2] or VTR [3].
2)
LOAD a Clip. If LEARNING a Gang, load all clips and set the Gang.
3)
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by
manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
4)
Press [SHIFT] + [MARK] to initiate the LEARN of the current configuration.
The display shows:
5)
Press VTR [2] or VTR [3] to select the VTRs.
6)
Press [MARK] and the ST300 will: LEARN (save) the Cue Point, CLIP IDs, IN
and OUT Times, Current Directory and Ganged VTRs.
b. LEARNING IN POINTS, GANGED CLIPS
If the master has no IN point, the current location of each clip in the gang will be learned
as IN points, IF the slaves have IN points, the slaved in points will be overwritten.
c. LEARN ON THE SHOTBOX
1) Press
[LEARN].
2)
Select Bank and press Shotkey
d. LEARN ON THE PRODUCTION SWITCHER
1)
Select and enable the Peripheral Device Addresses for the ST300.
2)
Do a LEARN to the desired REGISTER.
The ST300 will: LEARN (save) the VTR number, loaded CLIP ID, and current
time into the REGISTER number in the ST300.
Select VTR:
Learn - OK, ESC-Cancel