Daktronics Track & Field Interfaces - Manual (Page 7)

Introduction 1
Section 1: Introduction
This manual explains the settings required to send data to a Daktronics system from third-party
FinishLynx™ timing software and Hy-Tek Meet Manager
® results software.
For other questions concerning this system, refer to the telephone numbers listed in Section 4.
1.1 Resources
Figure 1 illustrates a Daktronics
drawing label. The drawing number is
located in the lower-right corner of a
drawing. This manual refers to
drawings by listing the last set of digits
and the letter preceding them. In the
example, the drawing would be
referred to as Drawing C-325405.
Reference Drawing:
System Riser Diagram ........................................................................... Drawing C-325405
Daktronics identifies manuals by the DD or ED number located on the cover page of each
manual. For example, this manual would be referred to as ED-14511.
1.2 Software Conventions
This manual contains the following software conventions and terminology:
Bold Indicates an item that requires direct action, such as clicking, pressing,
selecting or formatting.
Italics Indicates onscreen text or labels that are not clickable.
Bold Italics Used to reference items within the manual, such as figures or sections, as
well as other documents and important notes.
[X] Represents a keyboard key that needs to be pressed.
“Quotes” Text or commands that may be typed. Quotes also indicate folder names.
Click Press and release the left mouse button.
Double-click Press and release the left mouse button twice.
Right-click Press and release the right mouse button.
Select Highlight or mark, such as by placing a check mark  in a nearby box;
clicking will not necessarily perform an action.
> Followed by (ex. File > Open).
Figure 1: Daktronics Drawing Label