Daktronics Galaxy AF-3500 Series 46 mm - Manual (Page 51)

International Installation 47
Appendix C:
International Installation
Terminating Hot, Neutral, and Ground Wires at the J box
1. Route the power cable through conduit to the rear of the display and into the power
termination J box.
2. The power termination enclosure will contain two wires plus a ground coming from the
interior of the display. These wires are pre-terminated to the power termination panel
inside the display.
Note: The following colors are used for the pre-terminated wires:
240 VAC
Line 1 Brown
Neutral Blue
Ground Green/Yellow
3. Inside the display’s external power termination J box, connect the power wires to the
wires coming from the display interior using wire nuts. Refer to Figure 40.
Terminating Single-Phase Power to the Internal Power Termination
Panel
Daktronics displays used for international applications are equipped with different power
termination panels than domestic displays. However, the termination method is similar to
the domestic termination discussed in Section 3.5.
1. Open the display as explained in Section 6: and locate the power termination panel.
Figure 40: 240 V Power Termination