Daktronics Galaxy AF-3500 Series 46 mm - Manual (Page 19)

Signal Installation 15
4. The M2 Configuration Studio has two folders under the Configuration tab. Click the
Communications
folder.
5. Use the following
information for your
display to configure a
direct connection:
 Type: TCP/IP
 Address: 1 (Refer to
address dials on
controller for actual
setting)
 IP Address:
172.16.192.25
6. Click Network >
Connect, or click the Connect icon to connect to the display.
7. After connecting to the controller, select the Communications folder on the left side
of the screen then select TCP/IP:
Figure 17: Configure Connection
Figure 18: Connection Configuration
Figure 19: Connect