Daktronics Galaxy AF-3500 Series 46 mm - Manual (Page 36)

32 Part Replacement
Ribbon Assy, 36" 0A-1000-0018
Ribbon Assy, 42" 0A-1000-0019
Ribbon Assy, 60" 0A-1000-0021
Ribbon Assy, 72" 0A-1000-0022
Ribbon Assy, 96" 0A-1000-0024
Ribbon Assy, 108" 0A-1000-0025
Ribbon Assy, 24" 0A-1000-0074
Interconnect Cable; RJ45 W-1921
CAT5e; 30', RJ45 W-1999
Electrical Contact Cleaner/Lubricant CH-1020
Hex Wrench, T-Handle 1/8" RT for modules TH-1062
Wireless Bridge Communications Enclosure 0A-1327-1100
Wired Ethernet Communications Enclosure 0A-1327-1101
Fiber Ethernet Communications Enclosure 0A-1327-1102
Wi-Fi Communications Enclosure 0A-1327-1103
Label/Gasket RJ34 Primary Input 0A-1327-1028
Label/Gasket Assy, RJ45, Mirror Input Quick Connect 0A-1327-1029
Label/Gasket Assy, RJ45, Primary Input Quick Connect 0A-1327-1024
Harness, POL, PS(4 PIN) TO MOD, 36" 0A-1327-2150
Harness, POL, PS(4 PIN) TO 2 MOD, 36" 0A-1327-2155
Harness, POL LVD, PS TO 2 MOD, 60" 0A-1327-2105
8.2 Instructions for Replacing Parts
Module Replacement
Tool required: 1 /
8
" Hex wrench
If LEDs fail, do not attempt to replace individual LEDs. Return a failed module to Daktronics
for replacement and/or repair.
1. Turn off power to the display.
2. Follow the instructions in Section 6: to release the module from the display cabinet.
3. Unplug the power cables by squeezing the tabs on the sides of the plug head and
pulling out.
4. Disconnect the two ribbon cables from the module, noting the connection to the back.
To release the ribbon cables, spread the tabs on the sides, and then lift the cable head
from the jack.
5. Connect all three cables to the new module, and then tightly push the ribbon cable
tabs against the cable head. Carefully push the ribbon wires back into the cabinet to
clear them from the module edges.
6. Place the module into its proper location.