Cybex 770T Treadmill - Manual (Page 57)

Cybex Owner’s Manual
57
Stopping the Treadmill
Press Stop once to end the workout session and start the Workout Review. The treadmill will perform
a controlled belt stop and bring the incline to 0%. The accumulated data or the results of the Fitness
Test will be displayed for the duration configured in Setup for Review Time. Press Stop again to exit
to Dormant.
The function of the immobilization method: The purpose of immobilizing the treadmill is to prevent
unauthorized use. This can be accomplished by removing the e-stop key from the treadmill, un-
clipping it from the cord and putting it in a non-accessible place.
STEPS DISTANCE CALORIES CAL / HR BPM PACE TIME METs
COOL
INCLINE
END
PAUSE
SCAN
SHIFT
DOWN
FIT TEST
MANUAL
PROGRAMS
3 1 2
WEIGHT
CLEAR ALT
LEVEL
7
4
SPEED
ENTER
9
0
8
5 6
TIME SAVE
FAN OFF
FAN LO
FAN HI
START
QUICK
The emergency dismount: Follow the steps listed below if you experience pain, feel faint or need to
stop your treadmill in an emergency situation:
1. Grip handrails for support.
2. Step onto the top steps.
3. Pull the e-stop key off the console.
The function of the emergency stop: The e-stop key functions as the emergency stop. In an
emergency situation, remove the e-stop key from the treadmill and the running belt will come to a
stop.
Safety Sentry
WARNING: Falling hazard
• Place your feet on the two top steps when starting or stopping the treadmill.
• Wear the e-stop clip at all times.
The treadmill uses sensors to determine if you are on the running belt. When using the treadmill,
exercise in the center of the running belt, and between the end of the handrails and the console. If
you step off of the treadmill during a workout, the treadmill is designed to detect your absence and if
a user is not detected, the console will beep twice and display “Are you there? Touch the screen to
continue”. If there is no response in 20 seconds, the treadmill will exit Active Mode and the running
belt will stop.