Cybex 770T Treadmill User Manual
Page 23
Cybex Owner’s Manual
23
Connect the Display Cable
The display cable and CSAFE cable have the same connectors. The display cable is black, the
CSAFE cable is red.
1. Route the cables under all other cables and towards the base plate.
2. Plug the display cable, located at the bottom of the upright assembly into the communication
port of the controller.
3
4
5
6
2
1
Item Description
1
Controller
2
Communication port
3
Display cable, Black
4
CSAFE cable, Red (optional)
5
Coax cable (optional)
6
Power supply cable
Install the Power Supply
1. Install the power supply to the base using clamp and screw.
6
2
7
4
3
1
5
Item Description
1
AC Cord
2
7
Power Supply Inlet
3
8
Clamp
4
8
Gray Cable Clip
5
9
Screw
6
Console Cable DIN
Connector
7
Power Supply Output
2. Plug the AC cord into the power supply inlet.
3. Route console cable through the gray cable clip.
4. Connect the console cable’s DIN connector to the power supply output. Make sure the two
connectors snap firmly together and can not be pulled apart without pulling the sleeve back to
release it.