A/v configuration and fm radio presets – Cybex 770T Treadmill User Manual
Page 33
Cybex Owner’s Manual
33
A/V Configuration and FM Radio Presets
Perform this procedure if the unit includes the optional Wireless Audio Receiver Module.
Setting up the Cybex Wireless Audio Receiver Module requires four steps:
•
Determine the type of transmitter used (MYE 900MHz, Broadcast Vision 863MHz, etc. or TV FM).
•
Set A/V Device to “Wireless TV”.
•
Assign a TV channel number to each transmitter on the 770T console.
•
Add FM radio station presets (optional).
Tools Required:
•
Headphones (not included)
Determine transmitter type
There are two types of transmitters UHF or TV FM. UHF transmitters will have TV’s identified by
number, example TV1. TV FM transmitters will have TV’s identified with FM frequencies,
example 93.1.
UHF Transmitters
Follow procedure:
Setup UHF Transmitters
TV1
TV2
TV3
Follow procedure:
Setup TV FM Transmitters
TV FM Transmitters
93.1
97.5
102.7
For TV FM transmitters, record FM frequencies for all TV’s:
1
2
3
4
5
6
7
8
9
10
A/V setup mode
WARNING: Falling hazard.
When starting unit
•
Stand on two top steps.
•
Do not stand on belt.
1. Plug the power cord into a power outlet from a grounded, dedicated circuit as described under
Electrical Requirements in this chapter. Do not stand on treadmill during this procedure.
2. Ensure the power cord is not being pinched under the front of the treadmill.
3. Toggle the power switch on (|). Power switch is located under the front end of the treadmill.
The control panel will light up and be in the Dormant Mode.