Cybex 770T Treadmill User Manual
Page 35

Cybex Owner’s Manual
35
5. Press Scan to scan for available channels. The scan can take up to 10 seconds and then
display “TV-1 of #”. The “#” symbol is total number of strong UHF channels found. Some of
these channels may not be signals from the TV transmitters and need to be deleted.
Review channels
1. Tap Up
or
Down
to listen to available channels with the headphones.
2. Delete unwanted channels by pressing Delete to delete channel. Repeat process for additional
unwanted channels.
3. Adjust the Near/Far setting for channels that are available but not showing. Press Far to
change the setting from “FAR” to “NEAR”. Press
Scan to re-scan for available channels.
4. Tap Up
or
Down
to scroll through and verify all TV channels. If all TV transmitters
are stored, and they all correlate the TV number to the correct TV heard, setup is complete.
If not you may need to re-scan or adjust the transmitter codes (see documentation for your
transmitters to perform a code change.)
5. Tap Toolbox
then
Home
to exit setup.Transmitter setup complete.
6. Proceed to Add FM Radio Stations (optional).
Setup TV FM Transmitters
If your TV’s use FM transmitters, follow these instructions to assign a TV channel to each frequency.
1. Tap Setup at the main Toolbox screen.
2. Tap Scroll Right
to navigate to the
A/V Config icon.
3. Tap A/V Config to enter TV Configuration.
4. Tap Select Xmtr to select your transmitter type as “TV FM”.