Compuprint 4247-L03 - Manual (Page 57)

Barcode Guard Bar Enable:
BACKUP NONE
GUARD BAR YES or
GUARD BAR NO or
CHAR SET CS2
The printer will (YES) or will not (NO) include left, right and center Guard bars of
the barcode styles which use Guard bars based upon your selection. The Guard
bars extend into the human readable line of the barcode symbol when it is
enabled.
Interface Settings
Depending upon the installed Interface Board, the printer can be equipped with
different interfaces to connect to the host system. The possible interfaces are:
v
Serial RS-232/C
v Parallel Centronics
v USB 2.0
v Ethernet 10/100 BaseT LAN
The following describes how to configure the parameters of the possible interfaces.
Interface:
EMUL. OPTION
I/F TYPE AUTO or
I/F TYPE PARALL or
I/F TYPE SERIAL (*) or
I/F TYPE USB (*) or
I/F TYPE LAN (*) or
PARALL INTERFACE
(*)This item is displayed only if the interface board (Controller Board) installed on
the unit is equipped with this interface. The Parallel Interface is always present
whatever is the Controller Board.
AUTO All the installed interface installed onto the
interface board (controller) are active and the hot
port feature is operative.
SERIAL Only the Serial RS-232/C Interface is active. Hot
Port is not operative.
PARALLEL Only the Centronics Parallel Interface is active. Hot
Port is not operative.
USB Only the USB 2.0 Interface is active. Hot Port is not
operative.
Chapter 3. Configuring the Printer 45