Compuprint 4247-L03 - Manual (Page 136)

Table 17. Paper Handling (continued)
Fanfold Width: 76.2 to 431.8 mm (3 to 17 inches)
Copies: 1 original + 7 copies
(Chemical)
1 original + 5 copies
(Carbon Paper) Max. thickness 0.635 mm (0.025
inches)
Options
FRONT2 PUSH TRACTOR Option
Fanfold width:
76.2 to 431.8 mm (3 to 17 inches)
Copies: 1 original + 7 copies
(Chemical)
1 original + 5 copies
(Carbon Paper) Max. thickness 0.635 mm (0.025
inches)
Table 18. Physical and Electrical Characteristics
Interfaces: depending upon the Controller Board installed in the printer, the following
Interfaces can be available
Parallel
Centronics Compatible Bi-directional (IEEE-1284) nibble and byte modes
- 36 pin Amphenol connector, 7/8 data bits
Receive Buffer: max. 128 Kbytes
Serial RS-232/C and 9-pin connector
Baud Rate: 300 to 115200 bps, 7/8 data bits, DTR & XonXoff flow
control
Receive Buffer: max. 128 Kbytes
USB 2.0 USB 2.0 series connector (device)
Receive Buffer max. 128 Kbytes, max bandwidth 12 Mbit/sec
LAN Ethernet 10/100 BaseT RJ-45 connector
Automatic interface switching
Reliability
MTBF
Mean Time between failure: 10000 hours at 25% duty cycle
MTTR Mean Time To Repair: 30 minutes
Printer Life 5 years
Duty Cycle Operating: no limitations
Power Supply
UNIVERSAL
From 90 to 264 VAC (100 to 230 VAC −10% / +15%)
Heat Output Maximum 240W (820 BTU/hr), typical 154W (526 BTU/hr), idle
22W (75 BTU/hr)
Power Consumption Maximum 480VA, typical 300VA, idle 50VA
Power Management Automatically enters reduced power mode after 20 seconds idle.
Noise Level Draft Normal (Default), Impact Strong, Quiet Off Mode
Noise power
operating 6.8 bels
Noise pressure
operating 57.4 dbA
Noise power idling 3.9 bels
Noise pressure
idling 28.6 dbA
124 User's Guide