2 sine encoder 5v with biss (x2), Biss interface, Sine encoder 5v with biss (x2) – BECKHOFF AX2500 User Manual
Page 51: P.51ff, S.51
8.13.2
Sine encoder 5V with BISS (X2)
Connection of a single- or multiturn sine-cosine encoder (5V) with BISS interface as feed-
back (from firmware revision 6.68). During start-up of the servo amplifier the parameters
stored in the encoder eeprom are uploaded, after that phase only the sine/cosine signals
are used.
The thermostat contact in the motor is connected via the encoder cable to X2 and
evaluated there. All signals are connected using our pre-assembled encoder connection
cable.
If cable lengths of more than 50m are planned, please consult our customer service.
Frequency limit (sin, cos): 350 kHz
FBTYPE: 20
AX2500 Product Manual
51
BECKHOFF
06/2007
Electrical Installation
AX2500
See also other documents in the category BECKHOFF Equipment:
- Bus Terminal System (19 pages)
- EP-xxxx-xxxx (19 pages)
- BK2000 (30 pages)
- LC3100 (67 pages)
- BK4000 (28 pages)
- BK3xx0 (95 pages)
- BK5000 (12 pages)
- LC5200 (32 pages)
- BK7000 (29 pages)
- BK7500 (32 pages)
- BK7300 (40 pages)
- BK8100 (26 pages)
- BC2000 (28 pages)
- BC3100 (51 pages)
- BC7300 (48 pages)
- BC8100 (36 pages)
- BC3150 (112 pages)
- KL1012 (2 pages)
- KL1114 (2 pages)
- KL1164 (1 page)
- KL1232-xxxx (4 pages)
- KL1501 (19 pages)
- KL1512 (15 pages)
- KL2521-0024 (18 pages)
- KL2512 (21 pages)
- KL2612 (4 pages)
- KL2622 (9 pages)
- KL3062 (24 pages)
- KL3064 (20 pages)
- KL4132 (19 pages)
- KL4034 (25 pages)
- KL3302 (23 pages)
- KL3351 (18 pages)
- KS3681 (43 pages)
- KL4112 (18 pages)
- KL5001 (16 pages)
- KL5051 (17 pages)
- KL5101-0012 (21 pages)
- KS5111-0000 (21 pages)
- KL5121 (19 pages)
- KL6021 (20 pages)
- KL6051 (17 pages)
- Z1000 (2 pages)
- KL6071 (12 pages)
- Z1003 (2 pages)