BECKHOFF EL6900-FB - Manual (Page 82)

Function blocks
80 Function blocks for TwinSAFE logic terminals
3.14.3 FB ConnectionShutdown configuration in the TwinCAT System Manager
Figure 3-37: FB CONNECTION SHUTDOWN configuration
Use the buttons Deactivate1 and Deactivate2 to connect the input signals. Use the Settings button to the
right of the Deactivate(x) buttons to configure the inputs as normally open contact (NO) or normally
closed contact (NC).
Use the Deactivated button to connect the signal that indicates that the connection has been terminated.
Use the ‘Connection ID’ edit box to specify the connection ID of the connection to be terminated via the
block. The block uses the Connection ID, not the connection no. of the TwinSAFE connection.
The error state can be connected via the ‘Error’ button.
The ‘MapState’ and ‘MapDiag’ checkboxes are used to specify which FB diagnostic functions are mapped
to the cyclic process image.