Basler Electric BE1-700 Modbus Protocol - Manual (Page 71)

9376700991 Rev D BE1-700 Modbus™ Protocol 3-23
47381 Active Alarm Flags (Sum Flags) LSBs BM(16)
Read only:
Bits 15 to 13 - Spare
BIT 12 - Burn-in test failure
BIT 11 - Defaults loaded on demand, via front panel or serial command
Bit 10 - Defaults loaded because of an READ error
Bit 9 - Calibration defaults loaded
Bit 8 - Setting defaults loaded
Bit 7 - Watchdog failure
Bit 6 - Power Supply error
Bit 5 - Calibration error
Bit 4 - Analog failure
Bit 3 - EEPROM Read / Write Fatal error
Bit 2 - MPU Self-test error
Bit 1 - ROM (flash) Failure detected
Bit 0 - RAM Failure detected
47382 Active Alarm Flags (Prog Alarms) MSBs BM(16)
Read and Write:
Bits 15 - Spare
Bit 14 - Volts per Hertz alarm
Bit 13 - 60 Fuse Loss alarm
Bit 12 - Changes Lost alarm
Bit 11 - Freq Range alarm
Bit 10 - Watt Demand alarm
Bit 9 - Var Demand alarm
Bit 8 - Logic = None alarm
Bit 7 - Flt Rpt Timeout alarm
Bit 6 - Virtual Output 15 alarm
Bit 5 - Virtual Output 14 alarm
Bit 4 - Virtual Output 13 alarm
Bit 3 - Setting Group Change Active alarm
Bit 2 - Loss of IRIG-B sync or IRIG-B decode problem
Bit 1 - An override is active in one or more outputs
Bit 0 - EEPROM Non-fatal error
47383 Active Alarm Flags (ProgAlarms) LSBs BM(16)
Read and Write:
Bit 15 - User settings changed, ( 'EXIT' with 'Y')
Bit 14 - Power Reset Alarm, hard reset of MPU
Bit 13 - Clock problem, Real Time Clock has not been set
Bit 12 - Communicating Failure Alarm, read error on serial port
Bit 11 - Operating System Overload Detected Alarm
Bit 10 - Setting group override in effect
Bit 9 - Q Demand Alarm, excessive negative-sequence unbalance
Bit 8 - Neutral Demand Alarm
Bit 7 - Phase Demand Alarm
Bit 6 - Breaker Alarm #3
Bit 5 - Breaker Alarm #2
Bit 4 - Breaker Alarm #1
Bit 3 - Recloser Lockout
Bit 2 - Recloser Fail
Bit 1 - Breaker Fail Alarm
Bit 0 - Out 1 CKT Open Alarm
47384 Target Status MSBs BM(16)
Read:
Bit 15 - Spare
Bit 14 - Spare
Bit 13 - Spare
Bit 12 - 51C