Basler Electric BE1-700 Modbus Protocol - Manual (Page 15)

9376700991 Rev D BE1-700 Modbus™ Protocol 1-5
Figure 1-3. DOS Configuration Utility Screen - Password
Type 3 (Enable DHCP Client) and press the Enter key. Figure 1-4 will appear.
Note: This process (i.e.,
Enable DHCP Client) must
be followed to assign a static IP address.
Figure 1-4. DOS Configuration Utility Screen – Enable DHCP Client
You will be prompted to enable the DHCP client with a YES (
1) or disable it with a NO (2). Type 2 to
disable the DHCP Client and press the Enter key. After a few seconds, the following screen (Figure 1-5)
is displayed.