Avery Dennison SNAP Sonic Knife - Manual (Page 31)

Users Manual Sonic Knife w/500 Machine Maintenance •••• 31
Troubleshooting
Problem Probable Cause Remedy
Machine fails to power up Lack of power to machine Check that both ends of power cord on printer are
securely plugged in.
Confirm that the outlet the printer is plugged into
has power.
Confirm all Sonic Knife cables are securely plugged
in.
Stock does not advance
through Sonic Knife when
printer start button is
pressed
Jam in Feed Rollers Check Feed Rollers for obstruction or jam. If
necessary - Re-thread fabric through feed rollers.
Check to see Feed Rollers are clean.
Cut on one side of fabric only Out of level Knife Blade Follow Knife Blade leveling procedure on page 20
Fabric not centered on horn Check all label guides and mounting brackets to
make sure fabric is centered on horn.
Not cut on fabric Out of level Knife Blade Follow Knife Blade leveling procedure on page 20
Ground Detect “on” too soon Check to make sure home sensor triggers at TDC.
Sonic power supply off Make sure Sonic power supply is turned “on”.
Spring pressure too light Check Spring Pressure setting procedure on page 21
Spring pressure too heavy Check Spring Pressure setting procedure on page 21
Knife dwell setting incorrect Check Knife Dwell setting procedure on page 21
Sonic Power Supply not triggering
(the bar indicator on the top front
of the Power Supply should flash
for every cut. If it does not, the
Power Supply is not being
triggered)
Check the Proximity Switch adjustment on page 23