Avery Dennison SNAP Sonic Knife - Manual (Page 23)

Users Manual Sonic Knife w/500 Machine Maintenance •••• 23
Proximity Switch Adjustment
The Proximity Switch triggers the Ultrasonic Power Supply to begin generating
Ultrasonic energy during the cut. If the Proximity switch is not adjusted properly, the
Power Supply will not be triggered and the unit will not cut.
The Proximity Sensor Flag (see illustrations below) should be adjusted as shown.
The flag should be positioned so that there is a 0.015” (0.4mm) gap between the Flag
and the face of the Switch. And, in the home position, the proximity flag should be
approximately 25 degrees below the proximity sensor.
SWITCH
.015
PROXIMITY
UPRIGHT PLATE
COLLAR FLAG
PROXIMITY SWITCH
Note: Above view is looking down on top of machine.
25°
PROXIMITY SENSOR
PROXIMITY FLAG
SONIC KNIFE FRONT