Avery Dennison 7411 Print Server - Manual (Page 8)

S y s t e m R e q u i r e m e n t s
To use the print server for printing from a wireless network, you need an
802.11b/g wireless network. The wireless network consists of either of the
following:
♦ An 802.11b/g wireless enabled PC printing straight to the printer (Ad-Hoc
or Peer-to-Peer Mode).
♦ An 802.11b/g wireless access point allowing wireless and wired Ethernet
enabled computers to print to the print server (Infrastructure Mode).
To configure and print, you need the following:
1. The MAC address from the label of the print server (for example:
004017023F96).
2. The following information from your wireless network administrator:
♦ Wireless Mode (Infrastructure or Ad-Hoc)
♦ The SSID (service set identifier) for your wireless network.
♦ If you are using TCP/IP (recommended for Windows Networks) and are
not connected to a server that automatically assigns your IP address, you
need to set the printer in Static mode and assign a unique IP Address for
the wireless print server (for example: 192.168.1.14) and a subnet mask.
A router (default gateway) address is optional.
N e t w o r k P r o t o c o l s S u p p o r t e d
♦ TCP/IP:
LPD/LPR, FTP, or IPP
Raw TCP/IP (port 9100 or any chosen port)
NetBIOS over IP (with SMB)
NetWare (NEST)
NetBEUI
DLC
♦ Telnet
♦ WINS
♦ DHCP
1-2 Ethernet Operating Instructions