Avery Dennison 7411 Print Server - Manual (Page 43)

C o n t r o l l i n g I P A c c e s s
1. You can limit which remote hosts are able to access the printer by
setting up an IP address range.
2. From the side menu, click Admin. The Web Admin Configuration screen
appears.
3. Click Configure IP Access Control.
To Add Hosts:
1. Enter a range of remote IP addresses that are allowed access to the
printer. Any requests from hosts outside this range will be rejected.
2. Click Add.
3. Click the reset link at the bottom of the screen. The Reset Server screen
appears.
4. Click Submit and wait five seconds for the printer to reset. Even though
you submitted your changes on the previous screen, they do not take
effect until you reset the printer.
You must re-enter your access password to make any further changes to
the printer settings.
5. The range of accepted IP addresses is listed in the drop-down menu.
Using the Web Interface 4-19