Avery Dennison 7411 Print Server - Manual (Page 52)

If the print server is operating properly, all three LEDs blink
momentarily, then indicate the following activity:
LED Indicators Status
solid printer is on
blinking error Orange
off printer is off
solid Ethernet link (wired 10baseT)
blinking network activity Yellow
off no Ethernet connection
solid Ethernet link (wired 100baseTX)
blinking network activity Green
off no Ethernet connection
solid wireless link
blinking network activity
Yellow &
Green
off no wireless connection
4. Print a test label. See Chapter 1, “ Getting Started ” for more information.
Press the print server test button for about a second and a label should
print.
Use 6-inch long supply. If you are using supply that is shorter than 6
inches long, temporarily change your supply type to “continuous” to
print the entire test label. After printing the test label, change your
supply type to your previous setting.
If a label does not print, check the printer's display to see if it shows
a receiving status. If so, press Escape to exit receiving mode. Once
you see “Online Ready” on the display, print a test label again. If
this does not print or the printer does not display “Online Ready,” the
unit is locked up. Turn off the printer, wait fifteen seconds and then
turn it back on.
If the printer displays “Online Ready,” but is not printing, verify that
the parallel port settings did not change. The Parallel Port setting
should be “Internal” and the Mode setting should be “IEEE1284”.
(From the Main Menu, select Setup, Port Settings, Parallel Comm.,
Port and Mode.)
5-2 Ethernet Operating Instructions