Avery Dennison 6035 Equipment Manual - Manual (Page 26)

P r i n t i n g i n C o n t i n u o u s M o d e
In continuous mode, the printer prints one supply or a strip of
supplies all at once. Supplies may be thermal labels, tags, or
specialty paper. Whether you are printing in continuous mode
depends on the application you are running. Ask your System
Administrator if you are printing in this mode.
Before you begin printing, make sure the
handle is fully charged and attach the safety
strap of the printer to your wrist.
Most likely, the application you are running will have you print
labels in continuous mode as follows:
1. Press the trigger (or other key the System Administrator
assigns).
2. When printing stops, cut the supply and remove the strip.
R e m o v i n g S u p p l i e s
To remove supplies:
1. Peel Mode Only. Tear the backing paper just above the pinch
roller.
2. Open the supply cover completely.
3. Twist the supply roll or core while pushing down, and then pull
forward to remove.
Loading Supplies 3-11 TC6035EZEM Rev. C 10/98