Avery Dennison 6035 Equipment Manual - Manual (Page 17)

L o a d i n g f o r P e e l M o d e
Peel mode separates labels from the backing paper, which allows
you to print and apply labels immediately. You must load labels in
this mode when the on-demand sensor is enabled.
Confirm all loading procedures with your
System Administrator, because these
procedures can vary depending on the
application you are running.
To load your labels:
1. Turn the printer on. The printer initializes.
2. Start the application and maneuver to the point where it
prompts you to load the supplies.
3. Press the latch buttons as shown, and open the supply cover
completely.
Supply Cover
Latch Button
3-2 Loading Supplies TC6035EZEM Rev. C 10/98