Setting the cut position, Setting the cut position -12 – Avery Dennison Monarch 9855 Operator Handbook User Manual
Page 46
4-12 Operator's Handbook
Setting the Cut P osition
This function adjusts where the tag is cut. The printer adjusts the cut
position according to the black marks on the supply. You may need to adjust
for aperture supplies. Increase to move the cut up; decrease to move the
cut down.
To change the setting, from the Main Menu, select Setup, Supply, then
Positioning. Then, follow these steps.
1. Press or until you see
POSITIONING
Cut Pos
2. Press Enter/Pause. The current setting is displayed, for example:
Enter knife adj
[-300/300]: +0
3. Press or to change the cut position. Pressing decreases the
value (moves the cut down);
increases it (moves the cut up).
Note:
We do not recommend setting a positive cut position while using
extended backfeed. You may cut off the leading edge of the next
tag.
4. Press Enter/Pause when the number you need appears. Press
Escape/Clear until you see the Main Menu.