Avery Dennison Monarch 9855 Operator Handbook - Manual (Page 114)

10-10 Operator's Handbook
757 Load supplies (supply length mismatch), because the calibrated
supply length differs by plus or minus .25 inches from the
format. Press Feed/Cut.
758 Either the supply is not seen or the on-demand sensor is
broken. Check for a label jam, clear the supply path, or reload
supplies. This error may occur if you remove a label too quickly
in the on-demand mode.
762 Low Voltage. For DC-powered printers, recharge the external
battery. For AC-powered printers, check the power inlet where
the printer is connected. The acceptable voltage range is
between 90-132 V
R M S
and 180-264 V
R M S
. If more or less power is
received, unpredictable results may occur.
763 Waiting to dispense label. Press Feed/Cut.
764 Verifier scan error (bad scan) on label when using normal (no
overstrike) mode. Press Escape/Clear to clear the error and
continue printing. The printer recalibrates (feeds a blank label)
after this error.
765 The printhead has less than 8 bad dots. The printer can shift
bar code fields to avoid bad dots. You may need to press
Escape/Clear to continue printing. Print a test label to confirm
the number of bad dots.
768 Printhead has more than 8 bad dots within the format area or is
not connected. Connect the printhead.
772 Verifier scan error (bad scan) on label or multiple labels in a row
when using overstrike and continue mode. The verifier detected
three or more bad scans in a row. Press Escape/Clear to clear
the error and continue printing. The printer recalibrates (feeds a
blank label) after this error.
773 Verifier failure. The verifier is enabled, but not connected. Make
sure the I/O cable and/or serial cable is connected to the
verifier. Refer to your verifier's Operating Instructions for more
information.
791 The printer has an error pending. Turn off the printer. W ait 15
seconds (until the power light is completely dim) and turn it back
on. Resend the packets.