ART Pro Audio DMV-Pro - Dual True-Stereo Effects Processor - Manual (Page 51)

- 47 -
internally change patches when this happens; it just sets LCD (A)’s program change number to the number that it
receives.
DRY KILL / GLOBAL MIX
Dry Kill
Dry Kill is used when running the DMV-PRO with a
mixing board in a send/return fashion. (For a complete
description, see page 10.) To enable or disable Dry Kill,
turn Encoder (A) to switch the bottom line of LCD (A)
between ON and OFF. If Dry Kill is on, the effect’s dry
path is disabled. If Dry Kill is off, dry sound is allowed
to pass and each preset’s Mix control governs the ratio
of dry and wet signal.
Global Mix
Global Mix is a convenient way to set each preset’s Mix
parameter to a certain value. Global Mix is only
accessible when Dry Kill is off. LCD (B) displays the
Global Mix setting; by turning Encoder (B), you can turn
Global Mix OFF or set it to a percentage between 0 and
100.
NOTE: The Dry Kill state is retained when turning the DMV-PRO on and off. The Global Mix state, however, is not
retained; the unit defaults to each preset’s stored Mix level when power is turned on.
LCD VIEW ANGLES / FACTORY RESET
LCD View Angle Factory Reset
This parameter optimizes the viewing angle for the
DMV-PRO’s two LCDs. Turn Encoder (A) until the text
on the LCDs is the clearest.
To restore all presets to their original factory settings,
press the Edit (B) button and then press it again after
LCD (B) reads [ 0$11 #(2 2- "-T%(0,
$1$2 :
]. You will see
)$
in the Preset Display
after the Factory Presets have been restored. If any
other button is pressed at the prompt except for Edit, or
if it is not pressed again within 10 seconds, the DMV-
PRO will exit from Factory Reset mode (with your
former presets still intact).