ART Pro Audio DMV-Pro - Dual True-Stereo Effects Processor - Manual (Page 50)

- 46 -
MIDI/UTIL PARAMETERS
The MIDI/Util Parameters affect the whole unit are set in MIDI/Util Mode. To access this mode, press the MIDI/Util
button, then turn the Preset Encoder to scroll both LCDs through their separate list of parameters. To change the
value of any parameter, turn its corresponding Processor Encoder. Changes to MIDI/Util parameters take effect
immediately and do not have to be saved. To exit MIDI/Util mode, press the MIDI/Util button again.
CHANNEL NUMBER / MIDI DUMP
Channel Number MIDI Dump
This parameter sets the MIDI channel on which the
DMV-PRO will transmit SysEx messages and receive
both program change and SysEx messages. The MIDI
Channel can be set between 1 and 16, or to ALL, for
Omni mode. Turn Encoder (A) to change values. If you
select ALL, the DMV-PRO will receive program change
and SysEx data on all 16 MIDI channels, but it will only
send out SysEx messages on Channel 1. The MIDI
Channel is automatically saved whenever it is changed,
so when you are done, turn the Preset Encoder to view
another MIDI/Util parameter or press the MIDI/Util
button to exit this mode.
From this menu, press the Edit (B) button, to perform a
MIDI Dump. While the information is being sent, both
LCDs will read: [
0 T1,(22(T&
2
]. It may take a few seconds for the operation to
complete.
NOTE: Individual presets and the MIDI Map can be
dumped or loaded separately if the operation is initiated
by an external MIDI device such as a sequencer of
external controller. See page 51 for more information
on the DMV-PRO’s MIDI implementation.
MIDI MAP
To set the DMV-PRO’s MIDI Map, turn Encoder (A) to select an incoming MIDI program change number that you wish
to map. This control’s range is from 1 to 128. Turn Encoder (B) to set the corresponding DMV-PRO preset number
that will be recalled when that program change number is received. The range of preset numbers is from 1 to 100, or
OFF to disable the program change number from recalling any DMV-PRO preset. Repeat this process to map other
program change numbers.
NOTE: While setting the MIDI Map, you can also conveniently set the incoming program change number (in LCD (A))
by sending an external MIDI program change message on the DMV-PRO’s MIDI channel. The DMV-PRO will not