ART Pro Audio DMV-Pro - Dual True-Stereo Effects Processor - Manual (Page 15)

- 11 -
Setting Dry Kill and Global Mix:
To adjust Dry Kill or Global Mix, press the MIDI/Util button. Turn the Preset Encoder until [ 08 (++A ]
appears on the top line of LCD (A). Turn Encoder (A) to switch the bottom line of LCD (A) between ON and
OFF. If Dry Kill is on, the effect’s dry path is disabled. If Dry Kill is off, dry sound is allowed to pass and each
preset’s Mix control governs the ratio of dry and wet signal. Also, if Dry Kill is off, LCD (B) displays the Global
Mix setting. By turning Encoder (B), you can turn Global Mix OFF or set it to a percentage between 0 and
100.
Changing Dry Kill or Global Mix takes effect immediately and does not have to be saved. To exit MIDI/Util
mode, press the MIDI/Util button.
NOTE: The Dry Kill state is retained when turning the DMV-PRO on and off. The Global Mix state, however, is
not retained; the unit defaults to each preset’s stored Mix level when turning power on (i.e., Global Mix OFF).
MIDI Dump
By performing a MIDI Dump, you can save the DMV-PRO’s presets and MIDI Map to an external MIDI-
recording device. You can even directly transfer the presets and the MIDI Map from one DMV-PRO to another
one with a MIDI cable.
To perform a MIDI Dump, press the MIDI/Util button.
Turn the Preset Encoder until LCD (B) reads: [ 0$11 #(2 2- 3,. 0$1$21 : ]. When you press
the Edit (B) button, the preset information will be sent and both LCDs will read: [ 0 T1,(22(T&
2 ]. It may take a few seconds for the operation to complete.
NOTE: Individual presets and the MIDI Map can be dumped or loaded separately if the operation is initiated
by an external MIDI device such as a sequencer or an external controller. See page 51 for more information
on the DMV-PRO’s MIDI implementation.