AMETEK CSW Series - Manual (Page 84)

User Manual California Instruments
84 CSW Series
3.11.12
3.11.13 MEASUREMENT CAL FACTORS Menu
Figure 3-32: MEASUREMENT CAL FACTORS menu
The MEASUREMENT CAL FACTORS menu provides access to the measurement calibration
parameters. The parameters shown are for the mode of operation (AC or DC) selected. The
PHASE key must be used to toggle between the calibration screens for each of the three
phases. These parameters are password protected and can only be changed after the
calibration password has been entered. Refer to the calibration section in this manual for details
on performing a calibration.
The following calibration factors are available from this menu:
Entry Description
VOLT FS Full scale voltage measurement calibration factor. AC or DC
mode.
CURR FS Full scale current measurement calibration factor. AC or DC
mode.
3.11.14 OUTPUT CAL FACTORS Menu
Figure 3-33: OUTPUT CAL FACTORS menu
The OUTPUT CAL FACTORS menu provides access to the output calibration parameters.
These parameters are password protected and can only be changed after the calibration
password has been entered. For three phase configurations, the PHASE keys toggle between
the three calibration screens for each phase. Refer to the calibration section in this manual for
details on performing a calibration.
The following calibration factors are available from this menu:
Entry Description
VOLT FS Full scale voltage output calibration factor.
V HI-FREQ High frequency full-scale voltage output calibration factor.
VOLT ZERO Zero offset voltage calibration factor.
PHASE OFST Phase offset calibration factor. Compensates for phase shift
caused by AC amplifier.