beautypg.com

Leds, Push buttons, Leds push buttons – Zilog EZ80L92 User Manual

Page 37

background image

eZ80L92 Development Kit

User Manual

UM012913-0407

Operational

Description

33

LEDs

As stated earlier, LEDs D1, D2, D3, and D4 function as status indicators
for an optional modem. This section describes each LED and the LED
matrix device.

Data Carrier Detect
The Data Carrier Detect (DCD) signal at D1 indicates that a good carrier
signal is being received from the remote modem.

RX
The RX signal at D2 indicates that data is received from the modem.

Data Terminal Ready
The Data Terminal Ready (DTR) signal at D3 informs the modem that the
PC is ready.

TX
The TX signal at D4 indicates that data is transmitted to the modem.

Push Buttons

The eZ80Acclaim!

®

Development Platform provides user controls in the

form of push buttons. These push buttons serve as input devices to the
eZ80L92 microprocessor. The programmer can use them for application
development. All push buttons are connected to the general-purpose port
pins.

PB0
The PB0 push button switch, SW1, is connected to bit 0 of the general-
purpose port. This switch can be used as the port input.

PB1
The PB1 push button switch, SW2, is connected to bit 1 of the general-
purpose port. This switch can be used as the port input.