WaveWare Alert Utility - Manual (Page 28)

Step 2 – Configuration – Output – SNPP Protocol
To use SNPP Protocol for an Output, you will need to Configure the SNPP Paging Server that will be used with
this Application. To Add a SNPP Protocol Output Place a Check Mark next to “ SNPP Protocol ” and then Click on
the “ Configure SNPP Paging Server ” Button. See Fig. 39
Enter the Wide Area Service Provider’s SNPP Server Information into the Configure SNPP Server Screen.
Test the SNPP Server Configuration by Clicking on the “ Test SNPP Server ” Button. See Fig. 40
Fig. 39 SNPP Protocol
Fig. 40 Enter SNPP Server Information - Test
Type a “ Message ” and a “ Pager PIN Number ” and Click OK to send a Test Message to a Pager. See Fig. 41
If the Test Failed, Check the Server Information and PIN Number and Retest. See Fig. 42
Fig. 41
Enter Message and PIN Number
Fig. 42
Check Information and Retry Test
When Successful you will get the Test Message on the Pager.
Next: Step 2 – Output Configuration – Plain Text
28