WaveWare Alert Utility - Manual (Page 24)

Step 2 – Configuration – Output – SpectraLink
To use SpectraLink for an Output, you will need to Configure the SpectraLink that will be used with this
Application. To Add a SpectraLink as an Output, Place a Check Mark next to “ SpectraLink ” and then Click on the
“ Configure SpectraLink ” Button. See Fig. 33
Enter the “ Com Port ” attached to the SpectraLink System and Configure the Number of “ Retries and Delay Time ”
for Busy and No Answer. See Fig. 34
Fig. 33 SpectraLink
Click on the “Configure SpectraLink” Button
Fig. 34
Configure The Com Port and the Number of Retries
for “Busy” and “No Answer” with “Delay” Times
Next: Step 2 – Output Configuration – LED Message Boards
24