KBC Networks ESML6-FL2 - Manual (Page 48)

Ethernet Switch User Manual
Manual_sw-ESML6-FL2-Rev1106
Copyright © KBC Networks Ltd. Page 47 of 64 www.kbcnetworks.com
a) Aggregator Setting
The aggregator is configured as follows:
Item Descriptions
System Priority
To specify the LACP value. The switch with the smallest value has the
highest priority and is chosen as the active LACP.
Group ID
The user can link aggregation for two or more ports, and select “Group ID”,
and then click on the “Get” button.
LACP
If enabled, the group is set as a LACP static trunking group. If disabled, it is
set as a local static trunking group. All ports support LACP dynamic trunking.
If the connected switch supports LACP as well, a LACP dynamic trunking
group will be created automatically. If LACP is enabled, it can be set as
passive or active on each port.
Note: When link aggregation is being configured, STP must be enabled,
otherwise, the ring network may form a redundant link which could cause a
network storm.
Working port
The max ports that can be aggregated simultaneously. If it is a static LACP
trunking group, the extra port is used as backup in case of a port failure. If
it is set as a local static trunking group, the port number must be identical to
the trunking port number.
Add Add a port to trunking group.
Table 5-4 Aggregator
b) Aggregator information
This menu option allows the user to view the information after the LACP is configured.
Fig 5-11 Aggregator – Aggregator
Information