KBC Networks ESML6-FL2 - Manual (Page 37)

Ethernet Switch User Manual
Manual_sw-ESML6-FL2-Rev1106
Copyright © KBC Networks Ltd. Page 36 of 64 www.kbcnetworks.com
4.5 Commands for Link Aggregation
Commands Description
add trkgrp lacp
[on|off] workports
ports
create trunk.
: support 4 groups.
lacp [on|off]: on - the group is LACP static trunking.
off - the group is LACP local trunking.
:to assign the working port of the trunking group.
If it is static LACP trunking group, the extra port is used as
backup for a failure.
If it is local static trunking group, the port number must be
identical to the trunk ports.
:to assign 1 or more ports to the trunking group.
Eg. add trkgrp 1 lacp on workports 2 ports 1-4, or
add trkgrp 1 lacp off workports 4 ports 1-4
config trksyspri
configure the LACP priority number of the switch.
: the valid values are 1 to 65535.
show trkgrp display the info of trunking group
show trkgrpcfg display configuration of trunking group.
enable lacpstate configure the port as LACP passive or active port.
disable lacpstate set active port as passive port.
show lacpstate display if the port LACP status is passive or active.
del trkgrp
Delete a trunking group.
: trunking group ID(1-4)
config trkgrp
workports
configure the working port of the trunking group - only for
LACP static trunking groups.
: the LACP static trunking group ID.
: the port number that can be aggregated
simultaneously.
enable lacp change local trunking to LACP trunking mode.
disable lacp change LACP trunking to local trunking mode.
add trkgrp <1~4> ports
Add a port to the trunking group.
del trkprt trkgrp
<1~4> delete a port from the trunking group.