Junger Audio T*AP Television Audio Processor Edition - Manual (Page 9)

T*AP
5
Base Unit rear view
For fail safe operation the Base Unit provides two independent power supplies. These power supplies
operate in load balance. The status of both PS are displayed on the Base Unit front panel as well as on the
X*AP Remote Panel.
STATUS LED
shows the status of the device controller
INIT pressing the INIT button briefly will warm start the device controller.
Holding down the button until the STATUS LED flashes 3 times will initialize the
Base Unit to factory default
LAN RJ45 socket for Ethernet connection to a LAN
USB USB 2.0 type B socket to connect the built in USB >> serial converter with an
external PC
ISO-PWR LED lights up if the isolated 5V power supply for GPI /O application is turned on
GPI 25pin Sub-D female connector to interface with the 8 optical isolated general
purpose inputs
GPO 25pin Sub-D female connector to interface with the 8 switch over relay general
purpose outputs
Interface 1 slot to mount one of the optional interface boards (SDI, AES, analog)
Interface 2 slot to mount one of the optional interface boards (SDI, AES, analog)
METADATA IN 9pin Sub-D female connector to receive and send Dolby® serial metadata
METADATA OUT 9pin Sub-D male connector to send Dolby® serial metadata
SYNC IN 75Ohm BNC connector to connect with external sync sources
WCKL-OUT 75Ohm BNC connector to synchronize external devices to the T*AP internal
word clock
AES IN 1/2 – 7/8 AES3id inputs
AES OUT 1/2 – 7/8 AES3id outputs