T*ap – Junger Audio T*AP Television Audio Processor Edition User Manual
Page 15
T*AP
11
getting started – IP setup of the Base Unit
–
via web browser
* Read the default IP address printed on a label above the RJ45 Ethernet connector.
* Set up network parameters of the PC which meet the default IP address of the Base Unit
(net mask = 255.255.0.0).
* Connect the Base Unit with the PC either by an Ethernet cross over cable or by a switch.
* Open a browser and type IP address of the Base Unit into the URL field and press
This will open the AUDIO PROCESSOR tab sheet of the GUI.
* Click on
Enter the desired network configuration and press
Afterwards you must reboot the Base Unit in order to activate the new IP configuration.
Regarding Gateway address see above.
Important Note! After reboot neither the web browser nor the X*AP Remote Panel may be able to
communicate with the Base Unit. You must key in the new IP address in the URL field and change
the X*AP Remote Panel settings to attach this device again.