Junger Audio T*AP Television Audio Processor Edition - Manual (Page 21)

T*AP
17
setup GUI – SYSTEM – System Status
The System Status page provides a top level view of the various status information available for the device.
Device Status provides the hardware status of the Base Unit
Power 1 status of the first power supply (left hand side from rear)
Power 2 status of second power supply (right hand side from rear)
Temperature measured on the surface of the main PCB
Sync Lock turns red if the external sync source is removed or unstable
Processing Status
Bypass turns red if Bypass is activated
Upmix turns green if Upmix is activated
Interface Status
AES I/O turns red if an AES input that is internally in use (i.e you have routed it to
an input of a function block) has detected an error
SDI I/O Interface turns red if the SDI input is not locked (no or bad SDI signal)
Dolby Processing Status
Metadata turns red if Metadata are not valid
Decoder turns red if the input signal is not Dolby encoded (PCM or corrupted)
Encoder 1 status of the first encoder (if optional CAT561 is installed)
status of the D-E encoder (if optional CAT569 is installed)
Encoder 2 status of the second encoder (if optional CAT561 is installed)