Junger Audio T*AP Television Audio Processor Edition - Manual (Page 53)

T*AP
49
setup GUI – AUDIO PROCESSOR – Monitor
This Monitor is part of the audio processor and meant to monitor the individual processing blocks.
The monitor tap must be selected with the Source Block & Source Program parameters.
The actual tap will appear when you open the Overview pane.:
Source
Block the processing block that should
be monitored :
[OFF, Input, Input Conditioner,
Equalizer, Level Magic]
Program [Surround, 2L/2R, Aux] for 5.1 +2
[1L71R … 4L74R] for 4x2
program associated audio
channels processed by the
specified block
Downmix if you are about to monitor a
surround program. For 4 x 2
mode this parameter is not used.
Center [-12.0 … 0.0]
Mix Level (dB)
Surround (dB) [-12.0 … 0.0]
Mix Level (dB)
Output
Mute [Enable / Disable]
Attenuation (dB) [-80.0 … 0]
Mono [Stereo, L+R, LL, RR]
Output [0 … 2.000].
Delay (ms)