d&b V-Series User Manual
Page 7
Pos.
Component
Description
[1]
[2]
Z5380 V Flying frame
Flying frame center bar
The Z5380 V Flying frame is designed to support arrays consisting of:
–
Z0515/Z0516, V8/V12. Weight: 34 kg (75 lb).
–
Z0518 V-SUB. Weight: 64 kg (141 lb).
The weight of the V Flying frame including all rigging components is 25.4 kg (56 lb).
[3]
[4]
Z5382 V Safety chainset
Safety point(s)
The Z5382 V Safety chainset is supplied with the Flying frame.
The Flying frame is fitted with two safety points each equipped with a 2 t shackle to attach a
secondary safety device using the enclosed V Safety chainset (refer to Þ Chapter 2.8.
"Secondary safety" on page 16).
[5]
V Load adapter
The Flying frame is supplied with two Load adapter to allow single or dual pickpoint
operation. Each Load adapter is supplied with a pair of Locking pins 10 mm and a 2 t shackle
(refer to Þ Chapter 2.6. "Load adapter" on page 13).
[6]
V Load adapter Rota Clamp
In addition, the enclosed V Load adapter Rota Clamp allows single pickpoint operation in
combination with the d&b Z5147 Rota clamp for a maximum system weight of up to 500 kg/
1100 lb (also refer to Þ Chapter 2.6. "Load adapter" on page 13).
[P]
Park position
During transport the Load adapters should be stored at their park positions (refer to
Þ Chapter 2.6. " Load adapter" Þ " Fixing the Load adapter at Park position" on page
[7]
Front link (Frame)
Two additional Front links together with a pair of Locking pins 8 mm each are supplied with
the Flying frame. They are used to mount V-Series cabinets on top of the Flying frame for the
following setups:
–
Mixed V-Series array with V-SUB cabinets at the top of the column (refer to
Þ Chapter 3.2.3. "Mixed array" on page 28).
–
V-Series ground stack with the Flying frame as ground support (refer to Þ Chapter 3.4.
[8]
Mounting plate
An additional mounting plate is provided to accept industry standard inclinometers such as the
Teqsas LAP-TEQ line array positioning tool.
[9]
Splay link (Frame)
In connection with the Front links of the V-Series loudspeaker cabinets, the Splay link of the
frame is used to attach the first cabinet to the frame. By default, the Splay link of the frame is
fixed at «POSITION V8/V12». To accept V-SUB cabinets, the Splay link can be moved to
«POSITION V-SUB» (refer to Þ Chapter 2.9. "Splay link of the frame" on page 17).
During transport the Splay link should be folded back into its park position and secured by the
respective Locking pin.
[10]
Cable pick
An O-ring at the rear bottom of the frame slides out when releasing the respective Locking pin
to attach a cable pick (refer to Þ Chapter 2.10. "Cable pick" on page 18).
d&b V-Series Rigging manual (1.9 EN)
7