d&b V-Series - Manual (Page 14)

2.7. Suspension of the Flying frame
The suspension of the V Flying frame is carried out using one or
two V Load adapter(s), depending on the chosen type of
suspension (Single or Dual pickpoint operation).
The Load adapters are attached to the center bar of the Flying
frame and fixed using the two Locking pins of each adapter as
described in the previous section Þ 2.6. Load adapter
Þ Attaching the Load adapter to the Flying frame on page 13.
2.7.1. Single pickpoint operation
With "Single pickpoint operation" the position of the V Load
adapter defines the vertical aiming of the entire array.
The corresponding hole position is calculated using ArrayCalc.
Note: The target angle of the entire array is achieved when
the array is fully set up and hoisted as intended.
Attachment
1. Choose the appropriate hole position on the center bar
according to the ArrayCalc calculation and attach the Load
adapter correspondingly.
Þ If ArrayCalc displays a half numbered hole setting (half
grid) turn the Load adapter correspondingly.
2. Attach the Hoist connector chain or motor hook to the shackle
of the Load adapter.
2.7.2. Z5147 Rota clamp option
Alternatively, a V-Series array with a total system weight of up to
500 kg (1100 lb) can be suspended and horizontally aligned
from a single flying point using the d&b Z5147 Rota clamp. The
clamp allows the load to be attached to overhead bars or truss
with a tube diameter of up to 51 mm (2”).
The corresponding hole position is calculated using ArrayCalc.
Attachment
1. Choose the appropriate hole position on the center bar
according to the ArrayCalc calculation and attach the Load
adapter Rota clamp correspondingly.
Þ If ArrayCalc displays a half numbered hole setting (half
grid) turn the Load adapter correspondingly.
2. Attach the Rota clamp to the Load adapter.
Note: Please observe the relevant mounting instructions
which are enclosed with the Rota clamp.
ArrayCalc Single pickpoint
ArrayCalc Single pickpoint
d&b V-Series Rigging manual (1.9 EN) 14