Cabinet assembly below v8/v12 cabinets – d&b V-Series User Manual
Page 33
3.3.1.2. Cabinet assembly below V8/V12 cabinets
Preparations
To mount the cabinet assembly below already suspended V8/V12
cabinets, prepare the respective cabinet assembly in the same
manner as described in the previous section Þ 3.3.1.1. " Cabinet
assembly to Flying frame", Þ "2. Prepare the cabinets"
1. Attach the assembly to the array
1. Lower the array until the Front links of the top cabinet in the
cart fit into the slots at the front of the bottom cabinet in the
array while a second person secures the cart against moving
and tipping over.
2. Insert and lock the second Locking pins of the cabinet's Front
links on both sides.
2. Apply and fix the preset splay angles
1. Slowly lift the cabinet assembly out of the cart until all Splay
links have hooked into the preset Locking pins.
2. Stop lifting and insert and lock the second Locking pins (Safety
pins) to secure the Splay links in place.
Note: If the Splay links are not engaged automatically,
proceed in the same manner as described in the pervious
section Þ 3.3.1.1. " Cabinet assembly to Flying frame"
Þ " 4a. Apply and fix the preset splay angles manually" on
3. Connect the bottom assembly to the Splay link of
the upper assembly
1. With two persons raise the entire assembly until the Splay link
of the array's bottom cabinet hooks into the preset Locking pin.
2. Slightly lower the assembly to allow the second Locking pin
(Safety pin) to be inserted.
3. Insert and lock the second Locking pin (Safety pin) to secure
the Splay link in place.
4. Rig the cabling
Connect the flying cables and link cables according to the number
of amplifier channels and cabinets used.
5. Check the assembly
Before hoisting the array to its operating position recheck the
actual status of the entire assembly according to the checklist given
in Þ Chapter 4. "Safety and system checks" on page 39.
d&b V-Series Rigging manual (1.9 EN)
33