d&b V-Series - Manual (Page 13)

2.6. Load adapter
The Flying frame is supplied with two different types of load
adapters:
Type 1: 2 x V Load adapter, allowing either single or dual
pickpoint operation.
Type 2: 1 x V Load adapter Rota Clamp, allowing single
pickpoint operation in combination with the d&b
Z5147 Rota clamp for a maximum system weight of
up to 500 kg /1100 lb.
Both types allow for a full grid (1/1 PICKPOINT DETENT) or a half
grid (½ PICKPOINT DETENT) setting depending on the direction of
attachment to the frame's center bar.
The frame's hole index marked on one side of the center bar is the
reference for the direction of the Load adapter.
As an example, the graphics opposite show hole positions 17 and
17.5 in connection with the V Load adapter.
As an example, the graphics opposite show hole positions 17 and
17.5 in connection with the Y Load adapter.
Note: The same applies to the V Load adapter Rota Clamp.
Attaching the Load adapter to the Flying frame
WARNING!
Potential risk of personal injury and/or
damage to material!
Before attaching the Load adapter, check the 2 t. shackle is
properly fitted to the Load adapter and secured with a locked ring
cotter.
Ensure the Load adapter is properly attached to the center bar of
the frame and both Locking pins are inserted and locked securely
before lifting the array.
The Load adapter is attached to the center bar of the Flying frame
and fixed using its two Locking pins 10 mm.
Note: It is advisable to insert the Locking pins opposite each
other as shown in the graphic opposite.
Fixing the Load adapter at Park position
During transport the Load adapters should be stored at their park
positions [P].
For this purpose, insert both Locking pins of each Load adapter in
the same direction from the top, as shown in the graphic opposite.
V-Series Load adapter
Type 1/Type 2 Y-Series Load adapter
Type 1/Type 2
Direction of the Load adapter for:
Left: Full grid (1/1 PICKPOINT DETENT), shown: Hole 17
Right: Half grid (½ PICKPOINT DETENT), shown: Hole 17.5
d&b V-Series Rigging manual (1.9 EN) 13