d&b V-Series - Manual (Page 31)

2. Prepare the cabinets
1. On the rear first remove all Locking pins.
2. Preset the splay angles of all cabinets based on your
ArrayCalc simulation.
Note: If the cabinet assembly is connected directly to the
Flying frame, the splay angle of the first (top) cabinet must be
set to [0°].
3. On the top cabinet, release both Locking pins and slide out the
Front link.
4. Insert and lock one Locking pin to fix the link in place.
3. Attach the Flying frame
1. Lower the frame onto the first cabinet of the assembly until the
Front links fit into the slots at the front of the frame.
2. Insert and lock the second Locking pins of the cabinet's Front
links on both sides.
3. Release the Locking pin that keeps the frame's Splay link in its
park position.
4. Fold out the Splay link and reinsert the Locking pin.
d&b V-Series Rigging manual (1.9 EN) 31